 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] User defined curve surface geometry generation |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 19, 2019, 09:11
|
User defined curve surface geometry generation
|
#1 |
|
New Member
Join Date: May 2019
Posts: 25
Rep Power: 6  |
Hello,
I am looking for some suggestions regarding generating a self defined spline or curve between two points and then revolving it about its axis to produce a venturi geometry. My target is the shape optimization of venturi, for that i have to generate several curves/spline to study and optimize the shape of venturi (converging and diverging sections) in order to minimize the pressure drop and reversed flow/ turbulances. How should i approach for generating curved line/spline that can be changed or parametrized? Thanks in advance. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OF-extend: area-averaged pressure drop across one patch and one user defined surface | jgross | OpenFOAM Post-Processing | 0 | February 19, 2018 14:03 |
| [ICEM] How to cut the surface using curve | delliganesh07 | ANSYS Meshing & Geometry | 0 | August 11, 2017 12:03 |
| [Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
| [snappyHexMesh] Layers don't fully surround surface | EVBUCF | OpenFOAM Meshing & Mesh Conversion | 14 | August 20, 2012 04:31 |
| CFX 5.5 | Roued | CFX | 1 | October 2, 2001 16:49 |
Linear Mode
