|February 25, 2013, 12:10||
Flow through two geometries
Join Date: Jan 2013
Posts: 9Rep Power: 6
So I have a very preliminary question:
I have created a box then I needed a pipe to extrude from one of the faces. So I created a plane and created a circle and extruded it.
When I bring it into fluent the flow wont flow from the pipe to the box.
|February 25, 2013, 23:56||
Join Date: May 2010
Location: United Kingdom
Posts: 267Rep Power: 17
You can either create an interface or unite the solids.
To unite the bodies, use create > Boolean in DM, choose "Unite", then select both bodies.
To create a 1 to 1 mesh interface, select both the bodies in the "bodies" section at the bottom of the tree in DM. Then right-click and "Form New Part". Once meshed, you can assign an interface in Fluent.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Review: Reversed flow||CRT||FLUENT||0||July 20, 2012 13:03|
|Different flow patterns in CFX and Fluent||avi@lpsc||FLUENT||4||April 8, 2012 06:12|
|Flow meter Design||CD adapco Group Marketing||CD-adapco||3||June 21, 2011 08:33|
|mass flow in is not equal to mass flow out||saii||CFX||2||September 18, 2009 08:07|
|potential flow vs. Euler flow||curious ...||Main CFD Forum||23||July 21, 2006 07:40|