 |
 |
 |
|
|
|
[Sponsors] | ||||
February 26, 2013, 08:00
|
Mesh Quality
|
#1 |
|
Member
Sujay
Join Date: Apr 2010
Location: Karnataka, India
Posts: 41
Rep Power: 15  |
Dear All,
My geometry is similar to water tank with the inlet and outlet at offcenter along central axis. The inlet is submerged pipe, hence it has few single edges and multiple edges. Will they affect simulation ? During mesh quality check i get, message like Multiple edge, single Egde and Delaunay Violation asking for sub set creation. How to tackle this problem ? Thanks, Sujay Patil |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| Polyhedral Mesh Quality in Star-CCM+ | niazaliahmed | STAR-CCM+ | 3 | March 8, 2012 13:51 |
| [ICEM] Tetra mesh quality before and after prism layer | Chander | ANSYS Meshing & Geometry | 0 | December 25, 2011 22:04 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
Linear Mode
