Hex mesh for tangential junction
2 Attachment(s)
Hi,
I am new to ICEM meshing. I would like to mesh a tangential junction of two pipe with different diameters. The small pipe is connected tangentially to large pipe in a inclined angle of 27 degree. I tried to use ICEM to generate hex mesh but it not successful. Everybody has idea to mesh it? Thank you in advance |
Hexa or tetra ?
Show some pics of what you have tried. |
5 Attachment(s)
Hi BrolY
I use Hex mesh. I splited into 4 blocks as shown in (pic block) and associated the four edge to upper part of tangential curve (pic 1). - Associated the vertical edge to left tangential curve and edge to right tangential curve (pic 2&3) However, the upper face and front face is disappeared after re-meshed |
All times are GMT -4. The time now is 10:28. |