 |
 |
 |
|
|
|
[Sponsors] | ||||
January 30, 2018, 04:09
|
Modify radius ICEM
|
#1 |
|
New Member
Mathia
Join Date: Dec 2017
Posts: 7
Rep Power: 8  |
Hello, I have created a stepcylinder mesh in ICEM and I would like to do a couple of simulations with different cylinder radiuses. Is there any way to modify the cylinder radius with out doing it from scratch again?
Kind regards Mathia |
|
|
|
|
|
January 30, 2018, 05:52
|
yes
|
#2 | |
|
Senior Member
|
Quote:
It is possible. Go to transform blocking. select the blocks of cylinder ( if they are deleted recover them from VORFN). scale the blocks and while doing this select transform geometry as well ( and select the cylinder). That should get you where you need. Cheers MS |
||
|
|
|
||
|
February 3, 2018, 07:36
|
|
#3 |
|
Super Moderator
|
||
|
|
|
|
 |
| Tags |
| icem 16.2 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
| [ICEM] The ICEM Guide for CFX Users | JuPa | ANSYS Meshing & Geometry | 11 | September 4, 2017 09:43 |
| Cannot update new.3dm file in ICEM based on rpl file | jimmy871013 | Mesh Generation & Pre-Processing | 1 | June 20, 2017 02:21 |
| ICEM 10 mesh scale foe CFX | Korsh Mik | CFX | 2 | October 7, 2005 09:07 |
| ICEM CFD 5.1 Hex-Tet mesh merging failure | bogesz | CFX | 1 | January 29, 2005 06:46 |
Linear Mode
