|
[Sponsors] |
March 9, 2013, 15:13 |
Move the coordinate in ICEM
|
#1 |
Senior Member
Join Date: Nov 2012
Posts: 171
Rep Power: 13 |
Hi Everyone,
When I finished the mesh using ICEM, I found that the origin is not located in the expected place, but the relative scale of the computational domain is corrrect. So now I would like to move the coordinate system in ICEM. How can I do it in ICEM? I know this will make all the coordinates changed. Thank you in advance! H |
|
March 9, 2013, 16:06 |
|
#3 |
Senior Member
Join Date: Nov 2012
Posts: 171
Rep Power: 13 |
||
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PEM Fuel cell module meshes. ICEM vs workbench | aarvay | FLUENT | 24 | March 2, 2020 06:50 |
[ANSYS Meshing] Workbench 13: Structured Hexa Meshes | rooftop | ANSYS Meshing & Geometry | 19 | March 31, 2016 02:33 |
[ICEM] complex 2D meshing on ICEM | kassab | ANSYS Meshing & Geometry | 26 | April 14, 2014 21:02 |
[ICEM] Meshing adjacent wall geometry and simple ICEM questions | everdimension | ANSYS Meshing & Geometry | 25 | June 20, 2012 04:25 |
Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 03:39 |