[ICEM] Move the coordinate in ICEM

hz283 · March 9, 2013, 15:13

Hi Everyone,

When I finished the mesh using ICEM, I found that the origin is not located in the expected place, but the relative scale of the computational domain is corrrect. So now I would like to move the coordinate system in ICEM. How can I do it in ICEM?

I know this will make all the coordinates changed.

Thank you in advance!

H

diamondx · March 9, 2013, 15:59

using edit mesh -» transform -» translate you mesh ...

hz283 · March 9, 2013, 16:06

Thank you so much!

Quote:

Originally Posted by diamondx

using edit mesh -» transform -» translate you mesh ...

March 9, 2013, 15:13	Move the coordinate in ICEM	#1
hz283 Senior Member Join Date: Nov 2012 Posts: 171 Rep Power: 13	Hi Everyone, When I finished the mesh using ICEM, I found that the origin is not located in the expected place, but the relative scale of the computational domain is corrrect. So now I would like to move the coordinate system in ICEM. How can I do it in ICEM? I know this will make all the coordinates changed. Thank you in advance! H

March 9, 2013, 15:59		#2
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Tokyo, Japan Posts: 1,385 Blog Entries: 23 Rep Power: 28	using edit mesh -» transform -» translate you mesh ... __________________ Regards, New to ICEM CFD, try this document --> https://goo.gl/KAOIwm Ali

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
PEM Fuel cell module meshes. ICEM vs workbench	aarvay	FLUENT	24	March 2, 2020 06:50
[ANSYS Meshing] Workbench 13: Structured Hexa Meshes	rooftop	ANSYS Meshing & Geometry	19	March 31, 2016 02:33
[ICEM] complex 2D meshing on ICEM	kassab	ANSYS Meshing & Geometry	26	April 14, 2014 21:02
[ICEM] Meshing adjacent wall geometry and simple ICEM questions	everdimension	ANSYS Meshing & Geometry	25	June 20, 2012 04:25
Design Modeler to ICEM.....	Joe	CFX	0	January 24, 2008 03:39