|
[Sponsors] |
April 24, 2013, 10:57 |
Set Vertex Location?
|
#1 |
Senior Member
Javi
Join Date: Jan 2013
Posts: 276
Rep Power: 16 |
Hi guys,
I just want to know if itīs possible to give a explicit location to a vertex. I mean, select a vertex and give it x,y and z coordinates. Thanks! |
|
April 24, 2013, 11:25 |
|
#3 |
Senior Member
Javi
Join Date: Jan 2013
Posts: 276
Rep Power: 16 |
It was a lapse. I use this option everyday but usually itīs only to equalise location.
Thanks Diamondx! |
|
April 24, 2013, 11:33 |
|
#4 |
Senior Member
Javi
Join Date: Jan 2013
Posts: 276
Rep Power: 16 |
I have another one. Look the picture. Iīve asked a similar question in other thread. Is not possible get the internal vertex location? When I click in green one, appears a big yellow point but, if this is an internal one... appear a small yellow point (I suppose that this measure itīs not the real of the vertex).
|
|
April 24, 2013, 13:03 |
|
#5 | |
Super Moderator
|
Quote:
Here you have three options: 1. You are just talking about 2. Reference from "screen" Just create a point at required location and choose that point when you enable screen option 3. Don't choose any reference vertex or reference location. Just check X, y and z boxes and enter required location and apply. |
||
April 24, 2013, 13:19 |
|
#6 | |
Super Moderator
|
Quote:
|
||
April 24, 2013, 13:21 |
|
#7 |
Senior Member
Javi
Join Date: Jan 2013
Posts: 276
Rep Power: 16 |
Thanks Far. Iīve done this to set a location. But.. Do you know how to get the location of an internal vertex.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] Internal walls of zero thickness | anger | OpenFOAM Meshing & Mesh Conversion | 23 | February 6, 2020 18:25 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
how to move a set of vertex | cthsieh | Siemens | 2 | September 5, 2007 20:18 |
Determine the exact location of the vertex center? | Anna | Main CFD Forum | 3 | April 4, 2006 11:04 |
How to set transition location | DAK565656 | Siemens | 3 | September 6, 2005 05:44 |