[DesignModeler] DM- how to create Solid and Fluid _2D

ahvz · March 18, 2013, 07:20

Hi, How to create two different layer (2D) one is solid and another attached to this layer is Air (fluid). I have see only one body created for all geometry with its solid while is not the case that I expected
any help is welcome to my problem...
regards

diamondx · March 18, 2013, 09:43

in 2d, geometries are basically surfaces. use split faces. and rename them Fluid and sOLID.

ahvz · March 18, 2013, 10:38

Thank you Ali,

Now I have two bodies. how to connect this two together ? from one edge ? I tried "connect" option but there are not possible, let me know any ideas please...

March 18, 2013, 07:20	DM- how to create Solid and Fluid _2D	#1
ahvz Senior Member Moha Join Date: Mar 2013 Location: EU Posts: 103 Rep Power: 0	Hi, How to create two different layer (2D) one is solid and another attached to this layer is Air (fluid). I have see only one body created for all geometry with its solid while is not the case that I expected any help is welcome to my problem... regards

March 18, 2013, 09:43		#2
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Tokyo, Japan Posts: 1,385 Blog Entries: 23 Rep Power: 28	in 2d, geometries are basically surfaces. use split faces. and rename them Fluid and sOLID. __________________ Regards, New to ICEM CFD, try this document --> https://goo.gl/KAOIwm Ali

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Create solid mesh around fluid mesh	wcpvandervelden	OpenFOAM Meshing & Mesh Conversion	0	June 21, 2012 10:05
Actuator disk model	audrich	FLUENT	0	September 21, 2009 07:06
Where's the singularity/mesh flaw?	audrich	FLUENT	3	August 4, 2009 01:07
How to create multiple solid fluid domain?	Mishar	FLUENT	0	January 25, 2005 03:05

March 18, 2013, 10:38		#3
ahvz Senior Member Moha Join Date: Mar 2013 Location: EU Posts: 103 Rep Power: 0	Thank you Ali, Now I have two bodies. how to connect this two together ? from one edge ? I tried "connect" option but there are not possible, let me know any ideas please...