|March 27, 2013, 21:31||
Join Date: Mar 2013
Location: south korea
Posts: 2Rep Power: 0
i've a big big problem!
in ICEM CFD, when i clicked the backround or something(left side of mouse )
suddenly the mode was changed to create/midify curve mode!
so i couldn't do anything on ICEM
I couldn't choose anything or rotated the view... like that..
what is the prolem??????
and how can i solve it?
|March 28, 2013, 13:38||
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Blog Entries: 23Rep Power: 21
Never heard of this problem before try this:
-use the refresh button see if it can solve the problem.
-click on setting -» reset...
New to ICEM CFD, try this document --> https://goo.gl/KAOIwm
|March 28, 2013, 18:08||
Join Date: Jan 2012
Posts: 135Rep Power: 9
Might be your cursor is jumping or problem with the mouse.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Question about Geometry vs. Meshes||EphemeralMemory||ANSYS Meshing & Geometry||2||December 8, 2016 14:02|
|[ANSYS Meshing] need to convert a cell based geometry into STL or CGNS||kamran_kibria||ANSYS Meshing & Geometry||0||September 15, 2011 05:14|
|Reg difficulties in meshing the geometry...Urgent||arunraj||ANSYS Meshing & Geometry||0||August 26, 2011 23:25|
|SnappyHexMesh meshes inside and outside of an STL geometry||villier||OpenFOAM Mesh Utilities||17||June 15, 2010 19:51|
|[GAMBIT] import terrain geometry||cfdworker||ANSYS Meshing & Geometry||2||May 24, 2009 21:40|