 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Restriction on non flat surface |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 28, 2013, 18:07
|
Restriction on non flat surface
|
#1 |
|
New Member
Santiago
Join Date: Mar 2013
Posts: 1
Rep Power: 0  |
Hello, I'm trying to place a movement restriction on ANSYS of a roller support for a structure, but it's not on a flat surface, but on an slopped one... Can anybody tell me how to work this out please?
Thanks! ps: It's like the support on the right hand of the attached image, though my problem is with a 45 degree angle. ps2: If it's still too hard to understand, send me an email and I'll send you a diagram of the problem. Thanks! 
|
|
|
|
|
|
| Tags |
| ansys, movement, restriction, roller support, slopped |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Surface mesh not sticking to surface | holtwong | ANSYS Meshing & Geometry | 2 | April 20, 2023 09:28 |
| Simulation of varying contact angles for a large droplet of water on a surface | cp703 | CFX | 5 | July 20, 2013 07:08 |
| [ICEM] Automatic mesh generation script surface intersection problem | stuart23 | ANSYS Meshing & Geometry | 0 | May 13, 2011 02:10 |
| Recover surface from surface mesh in IcemCFD | Jerry Tanner | CFX | 0 | August 20, 2008 13:48 |
| free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 07:47 |
Linear Mode
