how to mesh this geometry
Hello,
I am working on this attached geometry ,and my goal is to set up an Fluid Flow(cfx) on Workbench,but a I'm having problems with the mesh. Can you help me with some guidelines and ideas for methods to use? Thanks in advance Konstantine http://i828.photobucket.com/albums/z...cfd-online.jpg |
|
Thanks a lot asal,but I don't know anything about meshing at the ICEM. :(
I have tried meshing the geometry at Ansys Meshing Application and those are my results http://i828.photobucket.com/albums/z...ktos14/cfd.jpg I think,they are very bad... How can I improve that mesh? Thanks in advance |
Inflation is a must and ofcourse to have fined mesh at inlet and outlet of the airfoil.
Boundary layer as fine as possible for accurate results. |
Hi!
You should employ some inflation layer (Prism) around the airfoil. Moreover by using some mesh controls refine the mesh at the rear side of the airfoil to be able to capture the flow in this area. |
do you need tutorials for ansys ? i can provide them for you
|
Thank you for your answers guys...!
I will do the proper changes and i will post the results... Diamondx...I have already the tutorials which included at the ansys... |
Hello!!
I believe I have done the proper changes! What is your opinion?? http://i828.photobucket.com/albums/z...tos14/cfd1.jpg |
All times are GMT -4. The time now is 00:22. |