 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] skin/loft with specific 3D curve? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 25, 2023, 06:11
|
skin/loft with specific 3D curve?
|
#1 |
|
New Member
Mohamad Younes
Join Date: May 2023
Posts: 2
Rep Power: 0  |
Hey all, (URGENT!)
I want to do a skin/loft in design modeler between 2 sketchs but not in a default way because i have a coordinate file (so 3D curve) with i want to use it for this skin/loft so i want the created body of the skin/loft forwarding these points between the 2 different sketches and not with the default way of designmodeler. Can i do this in designModeler? Thank you. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Continuity Equation for multicomponent simulation | lordluan | CFX | 15 | May 19, 2020 18:36 |
| Domain Reference Pressure and mass flow inlet boundary | AdidaKK | CFX | 75 | August 20, 2018 05:37 |
| Simulation of a single bubble with a VOF-method | Suzzn | CFX | 21 | January 29, 2018 00:58 |
| Defining Boundary Conditions Dictated by a Pump Curve | robtheslob | FLUENT | 5 | December 2, 2014 14:30 |
| block-structured mesh for t-junction | Robert@cfd | ANSYS Meshing & Geometry | 20 | November 11, 2011 04:59 |
Linear Mode
