|April 15, 2013, 10:41||
Hexa Meshing with inflation
Join Date: Mar 2013
Posts: 47Rep Power: 6
I need to know whether can we do a Hexa dominant meshing for the geometry which contains a solid body inside a symmetric fluid region and also to give inflation layer along the surface of the solid body..so that I can capture the flow over it properly...?? Kindly help me...with suggestions....And also in the named selection do i have to give the contact surface between solid and fluid as a contact region or will it come in the setup as cell zones...??
Thanks in advance...
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Hexa meshing of impeller and diffuser assembly||Nitin Dewangan||ANSYS Meshing & Geometry||14||September 13, 2016 09:41|
|[ICEM] Hexa dominant meshing||Pat84||ANSYS Meshing & Geometry||19||December 2, 2015 18:20|
|Wind tunnel hexa meshing in ICEM CFD 12.1||matheusguzella||ANSYS Meshing & Geometry||1||March 14, 2011 17:14|
|Hexa Block meshes in ANSYS Meshing?||siw||ANSYS Meshing & Geometry||3||July 31, 2009 10:40|
|Hexa meshing or Tetra meshing???||NITIN DEWANGAN||CFX||5||August 5, 2008 09:59|