 |
 |
 |
|
|
|
[Sponsors] | ||||
April 18, 2013, 15:53
|
ICEM Cfd Aspect Ratio
|
#1 |
|
New Member
Join Date: Apr 2013
Posts: 3
Rep Power: 13  |
Hey,
Do you have any tips how to set the growth rate, when using block mesh? I need smooth tranisiton between cells in the picutre.  Mike Last edited by diamondx; April 18, 2013 at 18:59. |
|
|
|
|
|
April 18, 2013, 23:48
|
|
#2 |
|
Super Moderator
|
go to pre mesh parameters > Match edges
For growth rate (to resolve viscous effect) you need to provide first cell height, meshing law, growth rate in edge mesh parameters. |
|
|
|
|
|
|
April 19, 2013, 13:07
|
|
#3 |
|
Member
venki
Join Date: May 2011
Posts: 84
Rep Power: 14 |
You have do proper mesh distribution.
|
|
|
|
|
|
|
April 19, 2013, 15:10
|
|
#4 |
|
New Member
Join Date: Apr 2013
Posts: 3
Rep Power: 13 |
Thank you very much guys. With Far's tip I solved the problem.
Best regards, Mike |
|
|
|
|
|
 |
| Tags |
| aspect ratio, icem cfd |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Learn ANSYS ICEM CFD | easy_astronaut | ANSYS | 2 | December 15, 2013 15:34 |
| [ICEM] Aspect ratio vs quality of a tetra mesh | vmlxb6 | ANSYS Meshing & Geometry | 5 | September 25, 2012 13:21 |
| Grid Aspect Ratio | harishameed33 | Main CFD Forum | 1 | August 11, 2012 22:35 |
| [ICEM] check aspect ratio | camoesas | ANSYS Meshing & Geometry | 2 | November 14, 2011 09:38 |
| [ICEM] Export unstructured periodic mesh from ICEM CFD to Fluent | ivanddd | ANSYS Meshing & Geometry | 1 | February 3, 2011 00:51 |
Linear Mode
