 |
 |
 |
|
|
|
[Sponsors] | ||||
[ICEM] Error in creating prism layers on an external flow geometry |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 20, 2013, 02:25
|
Error in creating prism layers on an external flow geometry
|
#1 |
|
New Member
Zubairkhan Kittur
Join Date: Apr 2013
Posts: 2
Rep Power: 0  |
Hi... !!!
I am getting an error after meshing an external flow over aircraft nose cone in ICEM-CFD. It says: "Error: prism didn't create prism.uns' Can someone help me with this ??  Thanks Zubair |
|
|
|
|
|
July 9, 2015, 02:47
|
|
#2 |
|
Senior Member
Join Date: Mar 2015
Posts: 250
Rep Power: 12 |
Hello Zubair,
did you solve this problem? I am getting the same error message when I am trying to re-create the prism mesh when I already have a complete mesh with prisms. Best regards, Kate |
|
|
|
|
|
|
June 5, 2017, 14:47
|
|
#3 | |
|
New Member
Ioannis Tzivinikos
Join Date: Mar 2017
Posts: 3
Rep Power: 9 |
Quote:
Kate, I think that the mesh file was partially saved this is why it is happening. Do your remember interrupting the saving process before recreating your prism mesh? Also when you save the prj. file using signs (like "+", "-", etc.) then the prism layers fail. All the best Last edited by tzivinik; June 6, 2017 at 09:10. |
||
|
|
|
||
|
| Tags |
| error, icem, meshing, prism layers |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Domain for external flow | chinc | Main CFD Forum | 2 | August 8, 2010 01:23 |
| flow over an airfoil 3d ( Geometry on icem cfd ) | dfmona | Main CFD Forum | 0 | April 13, 2010 23:32 |
| Simulation of Flow through Complex 3D Geometry | EmersonKB | CFX | 5 | July 2, 2009 08:17 |
| Icemcfd: Preventing prism inflation collisions? | Joe | CFX | 1 | July 31, 2007 09:13 |
| 2D cylinder, external, laminar and turbulent flow | Dave | FLUENT | 0 | December 6, 2006 20:42 |
Linear Mode
