CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (https://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] divide parts in ICEM (https://www.cfd-online.com/Forums/ansys-meshing/116545-divide-parts-icem.html)

ok___ko April 22, 2013 05:38

divide parts in ICEM
 
Hi, erveryone.

Here is my question. When I creat a geometry in ICEM, I put all edges in one part 'GEOM', so, after mesh, when I import them in FLUENT, and I need to set bondary conditions, it only shows 2 zones, which are ''GEOM" and "int_fluid". Could I split the part 'GEOM' into different edges as I draw and named them in the part 'GEOM'? I want them to be independent parts. Does anyone have any ideas, instead of recreat a new geometry.

I am looking forward to your reply, thanks.

RodriguezFatz April 22, 2013 06:05

In ICEM, at the lower left, you need to right-click on the "parts" section and chose "create new part". Here you can name it and select any block, geometry or whatever you want to be part of that new part. It will automatically "deleted" from the previous part.


All times are GMT -4. The time now is 11:28.