[ICEM] 3D model turbine housing mesh -- CFD Online Discussion Forums

May 6, 2013, 10:36

3D model turbine housing mesh

moseen

New Member

moseen aloor

Join Date: May 2013

Posts: 2

Rep Power: 0

Hi I am working on a project of turbocharger,
here casing model is done in nx software and i need mesh in icem software.
i have meshed it but quality of mesh is not good as shown in photo. so anyhow i need 2 get this quality more than 30% to proceed with turboGrid analysis. so plz help me to achieve this.
here are the step that have done for meshing.
1 imported igs file in icem
2 in mesh- surface mesh setup
maximum size -100
height- 1.4
height ratio-2
num of layers-5 - apply
4 compute mesh

Attached Images

untitled.jpg (30.3 KB, 24 views)

Last edited by moseen; May 6, 2013 at 10:38. Reason: not uploaded the photo

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface	Kryo	OpenFOAM Meshing & Mesh Conversion	13	February 17, 2022 07:34
CFD analysis on wind turbine rotor	Ken (Wind Turbine CFD Super Rookie)	Main CFD Forum	45	February 9, 2016 14:07
[snappyHexMesh] Layers:problem with curvature	giulio.topazio	OpenFOAM Meshing & Mesh Conversion	10	August 22, 2012 09:03
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10

All times are GMT -4. The time now is 10:28.