|
[Sponsors] |
May 8, 2013, 23:13 |
highly skewed elements in gambit
|
#1 |
New Member
omar
Join Date: Apr 2010
Posts: 26
Rep Power: 15 |
hi
i'm trying to mesh a gas turbine blade with cooling holes using Gambit, the mesh is structured, but in when i mesh a volume a message appears "mesh of volume 56 contains 36 highly skewed elements", however Gambit mesh the volume, at other times a similar message appears too, but Gambit dont allow to mesh the volume. my question is: if Gambit allow to mesh the volume can i to use this mesh? the area where the highly skewed elements are located isn't the area that i try to analyze. thanks in advance guys best regards |
|
May 13, 2013, 02:37 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
highly skewed cells mentionned from Gambit have skewness greater than 0.97, which should faild check mesh in fluent.
You can try working with this mesh, but if it diverges, or doesn't start, you know what you have to do...
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
May 13, 2013, 11:33 |
|
#3 |
New Member
omar
Join Date: Apr 2010
Posts: 26
Rep Power: 15 |
thanks a lot Max.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Highly Skewed Cells | chrisoturner | FLUENT | 7 | July 22, 2010 07:43 |
[GAMBIT] 3D skewed elements | chris21 | ANSYS Meshing & Geometry | 2 | May 6, 2010 22:15 |
active analysis elements in GAMBIT | yan | FLUENT | 0 | April 28, 2006 02:46 |
highly skewed elements | srikanth | Main CFD Forum | 1 | February 21, 2006 09:15 |
Gambit: skewed mesh | Christoph | FLUENT | 1 | November 7, 2005 13:32 |