[ICEM] Volume Generation Problem -- CFD Online Discussion Forums

May 9, 2013, 01:56

Volume Generation Problem

IbrahimSher

New Member

Ibrahim

Join Date: Apr 2013

Location: pakistan

Posts: 4

Rep Power: 12

There are four attachments with this question
1. Surface Mesh
2. Orfn defined using build topology
3. Boundary Sphere
4. Disoriented

volume mesh
How to correct this volume mesh?

Attached Images

May 10, 2013, 05:39		#2
jeevankumarb Member jeevan kumar Join Date: Mar 2009 Posts: 88 Rep Power: 17	Did you check the mesh for errors? if there are no errors then the mesher is not able to find a closed body. try to move the material body point inside the domain.

May 11, 2013, 17:20		#3
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Tokyo, Japan Posts: 1,385 Blog Entries: 23 Rep Power: 28	make sure the body FLUID is outside the plane. you enclosure is not big enough, might give you problem with convergence __________________ Regards, New to ICEM CFD, try this document --> https://goo.gl/KAOIwm Ali

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] volume mesh leaking out of the surface, in a multi zone problem	premchandpendota	ANSYS Meshing & Geometry	6	July 31, 2012 01:36
Negative cell volume problem in-cylinder	ziani.lotfi	FLUENT	0	April 11, 2012 07:54
[GAMBIT] Gambit - Problem having shadow wall on volume	ejvikings	ANSYS Meshing & Geometry	3	March 23, 2012 01:30
Ansys 12 Workbench problem when generating volume mesh	Sveink	ANSYS	5	January 6, 2010 03:17
Star-Design: Volume mesh generation error	fusij	Siemens	0	November 6, 2009 12:43

All times are GMT -4. The time now is 11:52.