CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ICEM] Geometry Trouble (

Emilio May 21, 2013 09:02

Geometry Trouble
Hello everyboby,

I have a problem to submit that's making me waste a lot of time.
I have to mesh a simple 3D geometry costing of two solids: a brick with a cylinder inside that's tangent to its four sides. However when i use ICEM in interactive mode override, I can't manage well geometry. When trying to associate the two circles (curves) to the matching edges it tells me that no edges has been selected for association. Is it not for i should split circles or the lateral surface of the cylinder into two halves?

Please reply me!


All times are GMT -4. The time now is 20:05.