 |
 |
 |
|
|
|
[Sponsors] | ||||
May 22, 2013, 14:27
|
Surface Orientation Problem
|
#1 |
|
Member
Lisandro Maders
Join Date: Feb 2013
Posts: 98
Rep Power: 14  |
Hi, I know there are a lot of threads about this problem, but in anyne somebody gives a good SOLUTION to the problem (unless I did'nt see it).
Well, to sumirise, when I check my mesh, which have about 2 milion of elementes, there are ONLY 4 elements with surface orientation problems.. When I try to create the .msh file for Fluent, I got the following message: "Error : face (near node 14578) is attached to more than 2 cells." Well, what I need to do?? Please give me solutions! And if there is some thread with the answer and I didn't see it please, send me the link! Thank you! |
|
|
|
|
 |
| Tags |
| error, orientation, problem, surface |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 07:41 |
| Problem in specifying the boundary condition for tank's surface which is on fire | BHE | FLUENT | 1 | March 22, 2013 00:02 |
| [Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 13:43 |
| Surface orentation problem in icemcfd | jeevan kumar | CFX | 0 | August 13, 2008 02:54 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 13, 2001 00:19 |
Linear Mode
