|
[Sponsors] |
March 12, 2014, 22:06 |
ICEM troblue for meshing Wedge geography
|
#1 |
New Member
訾海
Join Date: Aug 2013
Location: beijing
Posts: 4
Rep Power: 12 |
hi,Please.
I use ICEM to mesh wedge geography, but at the point of wedge, the mesh is not perfect(Picture mesh.jpg). my ideal mesh is on picture good.jpg how can i finish my mesh? i want help. Additionally, in my opinion, the troblue may relate to this problem in picture The quantities of the edge. there are 30 points in the edge 1 and 40 points in the edge 2. There are, however, 91 points in the edge 3 ! 30 plus 40 is not equal 91 apparently ! when i change the other quantities of edge 1 or 2, the sum of the quantities of edge 3 is 20 more than the sum of the quantities of the edge 1 and 2. Why and how to handle it? thx in advance. |
|
Tags |
mesh wedge |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to use an ICEM wedge geometry? | galap | OpenFOAM | 8 | January 4, 2017 05:31 |
[ICEM] Different meshes from ICEM and GAMBIT | Mojtaba.a | ANSYS Meshing & Geometry | 9 | March 30, 2013 02:42 |
Axisymmetric Whirl BCs; Wedge or Cyclic? | c_dowd | OpenFOAM Pre-Processing | 4 | December 5, 2012 10:38 |
Wall boundary is ignored when using wedge | Wedge | OpenFOAM | 1 | February 7, 2011 06:20 |
Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 03:39 |