CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ICEM] Geometry association (

ErshathG May 29, 2013 12:16

Geometry association
I am new to meshing with icem cfd. I am trying to mesh a s-shaped duct with elliptical to circle transition by creating O-Grid block. My doubt is after association of edges and curves,surface and it ok if the blocks protrude out of the actual geometry :confused:

Far May 29, 2013 13:48

do you get any problem in meshing? please show some pics

ErshathG May 29, 2013 15:20

1 Attachment(s)
got some problems with meshing...values of determinant in negative...but those elements are at a different location...i think the reason for that seems to be something else and am working on it...and sorry i cannot post the exact image..but i have added a image which might give some idea..the image corresponds to central plane...the red region is where the block protrudes out of the window,the yellow region is where i have the low quality elements...

Attachment 22239

All times are GMT -4. The time now is 08:47.