|
[Sponsors] |
May 31, 2013, 16:09 |
ICEM does not conform the settings
|
#1 |
Senior Member
Henry Arrigo
Join Date: Jun 2010
Location: Italy
Posts: 100
Rep Power: 15 |
Hello all
Anyone knows why ICEM does not conform the specified settings? Or may be I miss some steps? I follow the steps presented in the ICEM tutorial to build a structured mesh on wing body. But seems that it has no difference if I specify the element size or not. It always uses same sizing which brings back very coarse elements. Also, after assigning a different sizing on surfaces It does not even ask for updating when I am going to tick on the pre-mesh node. |
|
June 1, 2013, 02:03 |
|
#3 |
Senior Member
Henry Arrigo
Join Date: Jun 2010
Location: Italy
Posts: 100
Rep Power: 15 |
Many thanks Far. It works.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PEM Fuel cell module meshes. ICEM vs workbench | aarvay | FLUENT | 24 | March 2, 2020 06:50 |
[ANSYS Meshing] Workbench 13: Structured Hexa Meshes | rooftop | ANSYS Meshing & Geometry | 19 | March 31, 2016 02:33 |
[ICEM] Different meshes from ICEM and GAMBIT | Mojtaba.a | ANSYS Meshing & Geometry | 9 | March 30, 2013 02:42 |
[ICEM] Meshing adjacent wall geometry and simple ICEM questions | everdimension | ANSYS Meshing & Geometry | 25 | June 20, 2012 04:25 |
Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 03:39 |