[ICEM] Problem with blocks in 3D Mesh

brator · June 25, 2013, 05:13

Hey everyone,

I don't know too much about this software but I have some problems. I fit 3 blocks into my bent channel in order to mesh it properly(getting some help from tutorials tho).

Please take a look at picture 1 to see how I fit the blocks. Then, when I generate the pre-mesh, it generates weird shaped mesh in the bent section. You can see that from picture 2. However, I want a mesh there as at picture 3.

Could you tell me what the problem is and how I can fix that ?

Thanks.

brator · June 25, 2013, 06:18

Nevermind. I fixed that. There was a problem with associations.

FJSJ · June 25, 2013, 08:34

Hi brator,

I'm a bit confused because you are showing picture 1 different from picture 3. What do you really want to do? It seems an associated issue. Check your edge to curve association and even, if it´s necessary, make face to surface associations.

brator · June 25, 2013, 10:38

Hi FJSJ,

Thanks for the response. Sorry about the confusion, I just wanted to show what kind of mesh I wanted over the bent area. Picture 3 belongs to some other case.

Thank you a lot for the advise. As you said, there was an association problem with the edges. I reset the settings and associated them from beginning.

Cheers.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dynamic Mesh Problem.	Tom Clark	FLUENT	10	June 21, 2021 04:27
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
[Other] Mesh Importing Problem	cuteapathy	ANSYS Meshing & Geometry	2	June 24, 2017 05:29
dsmcInitialise - dsmcFoam	archymedes	OpenFOAM Pre-Processing	94	July 15, 2016 16:14
3D Hybrid Mesh Errors	DarrenC	ANSYS Meshing & Geometry	11	August 5, 2013 06:42

June 25, 2013, 06:18		#2
brator New Member Join Date: Jun 2013 Posts: 4 Rep Power: 12	Nevermind. I fixed that. There was a problem with associations.

June 25, 2013, 08:34		#3
FJSJ Senior Member Javi Join Date: Jan 2013 Posts: 276 Rep Power: 16	Hi brator, I'm a bit confused because you are showing picture 1 different from picture 3. What do you really want to do? It seems an associated issue. Check your edge to curve association and even, if it´s necessary, make face to surface associations.

June 25, 2013, 10:38		#4
brator New Member Join Date: Jun 2013 Posts: 4 Rep Power: 12	Hi FJSJ, Thanks for the response. Sorry about the confusion, I just wanted to show what kind of mesh I wanted over the bent area. Picture 3 belongs to some other case. Thank you a lot for the advise. As you said, there was an association problem with the edges. I reset the settings and associated them from beginning. Cheers.