CFD Online Logo CFD Online URL
Home > Forums a a > ANSYS Meshing & Geometry

[ICEM] thin cut problem

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   June 26, 2013, 04:57
Question thin cut problem
Senior Member
feizaghaee's Avatar
Join Date: Dec 2009
Posts: 132
Rep Power: 10
feizaghaee is on a distinguished road
Send a message via Yahoo to feizaghaee
hi all. I'm meshing a weir which has a thin cut. when I set edge criterion smaller than 0.03 after performing a tera mesh ICEM says that there is a hole in my geometry. how can I fix this problem?
thanks in advance
feizaghaee is offline   Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
conduction problem venkataramana OpenFOAM 3 December 1, 2013 08:30
Problem Importing Geometry ProE to CFX fatb0y CFX 3 January 14, 2012 20:42
area does not match neighbour by ... % -- possible face ordering problem St.Pacholak OpenFOAM 9 November 22, 2011 11:02
Problem in implementing cht tilek CFX 3 May 8, 2011 08:39
Thin surfaces within a body using DesignModeler? Forrest CFX 7 April 5, 2005 08:21

All times are GMT -4. The time now is 14:50.