CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ANSYS Meshing] First layer height decrease (

adudek July 3, 2013 05:46

First layer height decrease

I am running a Fluent simulation of a 2D model of a car in a wind tunnel, using k-epsilon method.

I'd like to have all my y+ along the top side of the car the nearest to 30 to have the better precision. The "problem" is that the velocity is increasing along the windshield (flow section decreasing), the same for the y+ values.

My question is : is there a way to decrease the size/height of the boundary cells elements from the bottom to the top of the windshield ? (to remain the y+ at \approx value)

Thank's in advance

All times are GMT -4. The time now is 17:56.