meshing
 

Dear all,
I am a beginner in Icem.Please help me for meshing the cyclone.I have made a block on the cyclone.when I mark "pre-mesh" a few line only appears in geometry please advise me for steps of meshing?





http://upload.tehran98.com/img1/ks3a...fofgrug71y.jpg

Go to Pre-Mesh Params> Update Sizes> Apply and then turn on Pre-mesh

Thank you so much.:)

Hi

How can i change the marked fine mesh size to the coarse one.I want to have a symmetrical mesh.

http://upload7.ir/images/41351030719297399022.jpg

Reduce the mesh size there

Blocking > pre mesh parameters > edge mesh parameters