ansys workbench mesh resulting part missing

vivid2727 · July 26, 2013, 10:37

I am trying to model a blade and do cfd via ansys workbench. I meshed the blade and in the pre-processing, part of the blade is missing, as shown. I would appreciate it if you could help me out this problem.

Thanks in advance.

Sixkillers · July 27, 2013, 15:04

It seems to me that your mesh is too coarse. What software did you use? Can you show the mesh?

Personally I would recommend you to use TurboGrid to generate mesh just for one blade and then copy it around in CFX-Pre.

vasava · July 29, 2013, 02:23

There could be some issues with your CAD model.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Workbench] mesh refinement of vortex tube using workbench	aqsa1590	ANSYS Meshing & Geometry	3	December 25, 2014 08:57
Block structured hexagonal mesh vs automated tetra mesh inside Workbench for CFD	Chander	CFX	3	November 27, 2011 16:24
mesh missing after export in gambit	morteza08	ANSYS Meshing & Geometry	1	July 26, 2010 01:10
mesh missing after export in gambit	morteza08	Main CFD Forum	0	July 23, 2010 02:19
ansys 11--icemcfd mesh or workbench mesh better	Nav	CFX	3	July 11, 2008 06:43

July 27, 2013, 15:04		#2
Sixkillers Member Join Date: Nov 2011 Location: Czech Republic Posts: 97 Rep Power: 14	It seems to me that your mesh is too coarse. What software did you use? Can you show the mesh? Personally I would recommend you to use TurboGrid to generate mesh just for one blade and then copy it around in CFX-Pre.

July 29, 2013, 02:23		#3
vasava Senior Member Paritosh Vasava Join Date: Oct 2012 Location: Lappeenranta, Finland Posts: 732 Rep Power: 22	There could be some issues with your CAD model.