|September 16, 2013, 02:42||
2d Undtructured mesh around airfoil with boundary mesh
Join Date: Aug 2010
Posts: 6Rep Power: 8
I am trying to create an unstructured mesh around airfoil S809. near the airfoil, I want to create boundary mesh.
however I search in the internet, I couldnt find any tutorial. can anyone tell me how it can be created?
the following steps i did, but i doesn't work
1. input the geometry file
2. create the domain
3. create a surface for the domain
4. trim the surface by the airfoil curves
5. delete the surface which obtained by trim
5. go to mesh. create unstructured mesh
6. go to curved mesh setup and set the Height, Height ratio and number of layers.
7. compute mesh
Thanks for your attention in advance
|September 19, 2013, 03:50||
Join Date: May 2013
Posts: 68Rep Power: 5
From my little experience the number of layers you specify is for quad mesh. if you need pure tri mesh then don't specify number of layers. I don't know what problem you are actually facing..
|airfoil, boundary mesh, curve mesh setup, unstructured|
|Thread||Thread Starter||Forum||Replies||Last Post|
|how to set periodic boundary conditions||Ganesh||FLUENT||13||January 22, 2014 05:11|
|Problem with airfoil shape optimization||robyTKD||SU2 Shape Design||6||June 13, 2013 19:13|
|Problem with restart solution in shape_optimization.py||robyTKD||SU2 Shape Design||21||May 29, 2013 09:26|
|Trimmed cell and embedded refinement mesh conversion issues||michele||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||2||July 15, 2005 04:15|
|New topic on same subject - Flow around race car||Tudor Miron||CFX||15||April 2, 2004 06:18|