 |
 |
 |
|
|
|
[Sponsors] | ||||
March 9, 2020, 03:16
|
AC Geometry problem
|
#1 |
|
Member
Muhammad Talha
Join Date: Feb 2020
Posts: 32
Rep Power: 6  |
HI,
I have imported a geometry of AC attached to a Room. The Problem is that they are acting as two different bodies. How can I make it as one body.. provided that Ac and room also there. i tried boolean operation of subtract but it makes a slot on the face where Ac is attached. then the whole fac acts as inlet but i want to give inlet to AC grills at front. kindly help me with this |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Airfoil simulation - Divergence of the results - Mesh or geometry problem ? | Pol.P | FLUENT | 9 | March 7, 2022 17:21 |
| Problem with Scale in Geometry | bejanyar | CFX | 4 | October 14, 2015 07:53 |
| [ANSYS Meshing] Problem with geometry | paul115 | ANSYS Meshing & Geometry | 4 | August 18, 2015 12:18 |
| [Workbench] Problem with the geometry | Memboro | ANSYS Meshing & Geometry | 0 | July 26, 2013 02:18 |
| [ICEM] [FLUENT] 2D Geometry problem when exporting to Fluent - Unwanted walls | MikeTichondrius | ANSYS Meshing & Geometry | 1 | February 9, 2011 13:31 |
Linear Mode
