|
[Sponsors] |
September 25, 2013, 02:28 |
ribbed passage with elliptical cooling holes
|
#1 |
New Member
raop
Join Date: Nov 2012
Posts: 3
Rep Power: 13 |
Hello,
I am trying to hex mesh a ribbed passage with cooling holes as shown in the images. I have also done the blocking for the passage portion, now i need to incorporate the holes and pipes as shown. Have been trying for the past 8-10 days but have been unsuccessful. Can someone guide me on this? Thanks in advance. raop Last edited by raorp; September 28, 2013 at 02:45. |
|
September 25, 2013, 07:52 |
|
#2 |
Member
Sam
Join Date: Mar 2009
Posts: 35
Rep Power: 17 |
Hey ,
I do not see any images ... |
|
September 25, 2013, 09:37 |
|
#3 |
New Member
raop
Join Date: Nov 2012
Posts: 3
Rep Power: 13 |
Hi sameben,
I had attached the images and had uploaded while creating the thread. I am looking into the procedure for putting those images again in this thread. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
modeling cooling holes in turbine blades | rajesh kumar gupta | Main CFD Forum | 1 | September 9, 2010 12:13 |
[TGrid] Inlet passage in turbogrid. | soldimix15 | ANSYS Meshing & Geometry | 0 | September 5, 2010 11:34 |
About Cooling channel | alefem | FLOW-3D | 1 | May 28, 2010 11:15 |
Unbelievably high velocity magnitudes in film cooling - HELP! | shankara.2 | FLUENT | 0 | June 1, 2009 22:43 |
Passive cooling system for batch reactor | Darek | Main CFD Forum | 0 | September 30, 2003 05:06 |