CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ICEM] Boundary conditions and parts do not transfer from ICEM to Fluent

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   September 26, 2013, 06:13
Default Boundary conditions and parts do not transfer from ICEM to Fluent
  #1
New Member
 
Leonidas Siozos-Rousoulis
Join Date: Jan 2013
Location: Brussels, Belgium
Posts: 11
Rep Power: 13
leonidassr is on a distinguished road
I have been trying to mesh a rod-airfoil configuration in ICEM in 2D in order to import the mesh afterwards into Fluent.

After the mesh was done, I assigned the boundary conditions to inlet, outlet, symmetric 1, symmetric 2, rod (wall) and airfoil (wall), however when reading the mesh in fluent, only the rod, the airfoil and symmetric1 appear.

After checking in ICEM just the mesh, without switching on the geometries, rod and airfoil appear as they should, while sym1 includes all 4 edges (sym1, sym2, in, out), and there is nothing to be seen for sym2, inlet and outlet.
On the other hand, when switching each part on, when looking at the geometries, they appear individually (as they should).

Any ideas?
leonidassr is offline   Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Impinging Jet Boundary Conditions Anindya Main CFD Forum 25 February 27, 2016 13:58
Boundary conditions Roby_1986 FLUENT 3 February 21, 2013 14:19
rotational periodic boundary conditions in ICEM user0314 ANSYS Meshing & Geometry 1 June 21, 2011 02:57
[ICEM] Problem with zones/bocos exporting ICEM model to Fluent hectordiaz ANSYS Meshing & Geometry 1 May 3, 2011 05:24
[ICEM] [FLUENT]How to provide boundary conditions thinktank ANSYS Meshing & Geometry 2 December 10, 2009 20:26


All times are GMT -4. The time now is 08:26.