[ICEM] Problems to create a surface in ICEMCFD

c120613 · October 7, 2013, 06:00

Dear All, I am a beginner in using ICEMCFD and by considering four different edges. These were, in turn, obtained by merging different segments. After creating the surface, this does not look so regular as shown in the attached file. Does anyone have an idea about what happened? Many thanks in advance

FJSJ · October 7, 2013, 09:52

Hi Domenico,

I´m not sure to understand your question but.... try to right click on surface in model tree.. and then choose show full... maybe this options can do you can see correctly.

diamondx · October 7, 2013, 12:32

try selecting the edges in a specific order, this is how it should be done with the points, i don't know about the edge, just try it.

October 7, 2013, 12:32		#3
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Tokyo, Japan Posts: 1,385 Blog Entries: 23 Rep Power: 28	try selecting the edges in a specific order, this is how it should be done with the points, i don't know about the edge, just try it. __________________ Regards, New to ICEM CFD, try this document --> https://goo.gl/KAOIwm Ali

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 12:43
Where's the singularity/mesh flaw?	audrich	FLUENT	3	August 4, 2009 01:07
Help ! Create surface for sliding mesh.	YH Tan	FLUENT	0	October 5, 2008 04:21
Surface creation problems with GAMBIT !	enemi09	FLUENT	2	February 26, 2005 10:52
create new surface	subhash	Siemens	2	July 30, 2002 03:53

October 7, 2013, 09:52		#2
FJSJ Senior Member Javi Join Date: Jan 2013 Posts: 276 Rep Power: 16	Hi Domenico, I´m not sure to understand your question but.... try to right click on surface in model tree.. and then choose show full... maybe this options can do you can see correctly.