 |
 |
 |
|
|
|
[Sponsors] | ||||
October 8, 2013, 08:31
|
Very thin annular space.
|
#1 |
|
Member
prince
Join Date: Jun 2011
Posts: 56
Rep Power: 14  |
Dear Friends
I am facing difficulty in meshing. Details of geometry is like this 1) There is cylinder of diameter 154 mm of length 90 mm. 2) With this cylinder, an annuls cylinder of length 203 mm (of diameter 154 mm and 153.8 mm) is attached. So the annulur space is very less (0.1 mm) through which flow occurs. 3) There is small horizontal pipe which is attached to cylinder (point 1) from where inlet of gas is provided into cylinder. diameter of small horizontal pipe is 6.264 mm) I am not able to mesh this geometry may be because of very small annular space. I am looking in any guidance how to mesh it properly. Looking forward for any help |
|
|
|
|
|
October 9, 2013, 00:43
|
|
#2 |
|
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
post pictures describing your point 3
__________________
In memory of my friend Hervé: CFD engineer & freerider  |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] airflow in an annular space between outer and inner pipe | malay | ANSYS Meshing & Geometry | 23 | February 28, 2013 12:58 |
| How to model the NR eqns in a domain with empty space | Vasilis | Main CFD Forum | 1 | April 14, 2009 04:35 |
| Fatal error error writing to tmp No space left on device | maka | OpenFOAM Installation | 2 | April 3, 2006 08:48 |
| Thin surfaces within a body using DesignModeler? | Forrest | CFX | 7 | April 5, 2005 08:21 |
| Modelling thin surfaces in 5.6 | Louwrens | CFX | 0 | August 16, 2003 10:47 |
Linear Mode
