 |
 |
 |
|
|
|
[Sponsors] | ||||
October 19, 2013, 15:51
|
blocking
|
#1 |
|
Member
WALI HASAN
Join Date: Sep 2013
Posts: 42
Rep Power: 12  |
hello dear
i want to do blocking in circular domain of radius 40m consist two cylinders of 1m diameter, each separated by 2m in such a way one cylinder is on one side of origin and the other cylinder on the other side of origin. please help me how can i do blocking ... thanks in advance |
|
|
|
|
|
October 21, 2013, 05:25
|
|
#2 |
|
Member
Join Date: Dec 2012
Posts: 92
Rep Power: 13 |
Hi
I think what you mean should look a little bit like this. Except, you know, the crappy angle and aspect ratios of course. Best wishes |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Gas separator blocking | RodriguezFatz | ANSYS Meshing & Geometry | 10 | March 6, 2013 10:12 |
| [ICEM] Problem to load the blocking | biasilveira | ANSYS Meshing & Geometry | 2 | February 24, 2013 22:04 |
| [ICEM] Blocking and Symmetry | BrolY | ANSYS Meshing & Geometry | 32 | August 24, 2012 03:13 |
| [ICEM] Using Blocking with ICEM (infinite blocking lines appeared) | Touré | ANSYS Meshing & Geometry | 2 | August 5, 2012 17:27 |
| [ICEM] Blocking strategy | BrolY | ANSYS Meshing & Geometry | 0 | July 22, 2010 04:46 |
Linear Mode
