|
[Sponsors] |
[ICEM] Problem continuing 2D boundary layer to adjacent surface |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 11, 2013, 08:33 |
Problem continuing 2D boundary layer to adjacent surface
|
#1 |
New Member
Rupert Wildhofer
Join Date: Jul 2011
Posts: 1
Rep Power: 0 |
Dear all,
I'm having problems creating a satisfactory 2D boundary layer. Specifically, the b-layer at the wall is not continued properly to the lines without boundary layer (i.e. inlet and outlet), see attached picture. The max. prism angle is set to 180°. It's noteworthy that the problem does not exist for my 3D meshes. Any help is much appreciated! Thanks, Rupert |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
Catalyst Modelling Boundary Problem (Surface reaction) | Fritz | STAR-CCM+ | 0 | August 6, 2013 09:10 |
Boundary layer meshing problem in Gambit | Crystal | FLUENT | 0 | June 12, 2009 20:58 |
Boundary layer meshing problem in Gambit | Crystal | Main CFD Forum | 0 | June 12, 2009 14:32 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |