CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ICEM] error in msh file (

aktm October 22, 2013 10:17

error in msh file
Hi there,

I deal with a hard disk drive model meshing for LES.

Iím having a trouble with writing out fluent mesh(.msh) file. In the file, I found a lot of #IND characters.

I checked blockings and other parameters but cannot find good ways.Is there any solutions?



cesarcg October 28, 2013 14:53

can you post the errors in the mesh warned by icem or fluent?


aktm November 11, 2013 04:59

I've found a solution. I think this error occured because of wrong agreement of vertexes and points.

All times are GMT -4. The time now is 12:57.