Fluidized bed in Gambit
Hi all
How to draw fluidized bed with the distributor consisted of a perforated plate of open area ratio 1.2% in GAMBIT ? Thanks in advance. |
do you have a sketch of what you want to draw?
|
Hi
a sketch of my geometry attached. My problem is in drawing distributor at bottom of the bed http://s3.picofile.com/file/79822126...idized_bed.png |
do you have a picture of this distributor?
|
No i don't have a picture of distributor .this geometry is in a paper and i want reproduce results of that paper .
in paper only that picture shown.And has written about the distributor : The distributor consisted of a perforated plate of open area ratio 1.2%. i don't know how to draw this geometry in gambit |
Then draw a plate, which is perforated from N holes with diameter D
The ration between cumulated hole-area (0.25.N.pi.D^2) and inital plate is given (1.2%). Ther is also the possibilty to work with porous media or something like that, but I neved used it http://www.cfd-online.com/Forums/flu...ed-plates.html |
My geometry is 2D.how i can calculate number of holes?
|
|
Perforted plate in 2d
Hi could you help me here. I have also the problem like you described. did you have any solution for air distributor design inside bed. could you guide me here.
|
Wholesale Perforated Metal Mesh Sheet
|
All times are GMT -4. The time now is 19:32. |