 |
 |
 |
|
|
|
[Sponsors] | ||||
November 1, 2013, 02:57
|
3D Model Meshing Issues
|
#1 |
|
New Member
Ikhsan
Join Date: Sep 2013
Posts: 15
Rep Power: 12  |
hi.
i intend to mesh a 3d coldplate with fins, along with 6 thermocouples drilled at each side. the mesh size of each slot should be around 0.1mm as the diameter of the slot is around 1.6mm. how can i mesh the slots with a size of 0.1 but mesh the rest of the model at a larger size? |
|
|
|
|
|
November 4, 2013, 01:36
|
|
#2 |
|
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
with the use of size function: https://www.sharcnet.ca/Software/Gam...ide/mg0502.htm
__________________
In memory of my friend Hervé: CFD engineer & freerider  |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compressible turbulence model issues | 351Cleveland | OpenFOAM | 5 | October 24, 2013 15:41 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
| [ANSYS Meshing] ANSYS Meshing hangs at "Preparing to model boundary for part" | jonny_b | ANSYS Meshing & Geometry | 12 | June 12, 2012 01:55 |
| ICEM: Projectile Meshing and Modelling Issues | gman89 | ANSYS | 0 | May 11, 2011 23:01 |
| 2 stage axial turbine model convergence issues | sherifkadry | CFX | 2 | September 7, 2009 20:51 |
Linear Mode
