 |
 |
 |
|
|
|
[Sponsors] | ||||
November 6, 2013, 02:58
|
Bladegen data import wizard
|
#1 |
|
Member
Arslan
Join Date: Jan 2011
Posts: 37
Rep Power: 15  |
Hi everyone;
I draw a 3D hydraulic turbine blade in Solidworks and import it into Ansys Bladegen in Igs format using Data import wizard. I submitted whole step but at the last step it asks for Leading Edge and Trailing Edge eliptic ratio. There are red squares, at both LE and TE and asks to confirm these points. How should i replace and submit them? What are these squares defining? When i pass this step and open the final geometry in TurboGrid or Design modeler trailing edge is generated as cutted randomly which is wrong. What can be the problem ? Best Regards. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Import to Bladegen | hasbi | CFX | 13 | November 9, 2014 04:42 |
| [Other] [DesignModeler] import data XYZ | zelito | ANSYS Meshing & Geometry | 0 | December 15, 2009 14:48 |
| Import validation data to CFX Post | Vattenkraft | CFX | 0 | November 26, 2009 19:55 |
| import spline data format | Chris | Siemens | 0 | March 30, 2005 13:09 |
| I-DEAS CAD data import with boundary conditions | Yunus | Siemens | 1 | June 1, 2001 10:04 |
Linear Mode
