 |
 |
 |
|
|
|
[Sponsors] | ||||
October 22, 2013, 10:17
|
error in msh file
|
#1 |
|
New Member
Akihiro Tamaru
Join Date: Oct 2013
Location: Japan
Posts: 3
Rep Power: 12   |
Hi there,
I deal with a hard disk drive model meshing for LES. I’m having a trouble with writing out fluent mesh(.msh) file. In the file, I found a lot of #IND characters. I checked blockings and other parameters but cannot find good ways.Is there any solutions? Thanks Akihiro |
|
|
|
|
|
October 28, 2013, 13:53
|
|
#2 |
|
Member
Cesar
Join Date: Nov 2012
Location: Guanajuato, México
Posts: 78
Rep Power: 15 |
can you post the errors in the mesh warned by icem or fluent?
regards. |
|
|
|
|
|
|
November 11, 2013, 03:59
|
Thanks
|
#3 |
|
New Member
Akihiro Tamaru
Join Date: Oct 2013
Location: Japan
Posts: 3
Rep Power: 12 |
I've found a solution. I think this error occured because of wrong agreement of vertexes and points.
|
|
|
|
|
|
 |
| Tags |
| fluent, mesh 3d, msh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
| [swak4Foam] swak4foam building problem | GGerber | OpenFOAM Community Contributions | 54 | April 24, 2015 16:02 |
| [swak4Foam] problem on installing swak4Foam | navid2 | OpenFOAM Community Contributions | 2 | May 30, 2012 04:32 |
| "parabolicVelocity" in OpenFoam 2.1.0 ? | sawyer86 | OpenFOAM Running, Solving & CFD | 21 | February 7, 2012 11:44 |
| DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |
Linear Mode
