|
[Sponsors] |
December 1, 2013, 17:04 |
Ansys Workbanch - Adhesive layer
|
#1 |
New Member
Join Date: Dec 2013
Posts: 1
Rep Power: 0 |
Can anyone help in modelling an adhesive joint in Ansys? Main intension is to find out the stress distribution within the adhesive layer in the simplest lap joint between two copper surfaces. The thickness is 0,1 mm and 1 mm of the adhesive and adhered surfaces ,respectively.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Collapsing layers | michi.ka | OpenFOAM Meshing & Mesh Conversion | 6 | September 22, 2018 09:20 |
[snappyHexMesh] SnappyHexMesh AddLayer Control | rdrr84 | OpenFOAM Meshing & Mesh Conversion | 28 | May 30, 2014 05:32 |
[ANSYS Meshing] inflation layer issue on Ansys 12.0 | IvanCFD | ANSYS Meshing & Geometry | 11 | April 8, 2014 05:54 |
[snappyHexMesh] Effect of adding layers with sHM | Nucleophobe | OpenFOAM Meshing & Mesh Conversion | 4 | August 20, 2012 16:45 |
Modeling both radiation and convection on surfaces - Ansys Transient Thermal R13 | s.mishra | ANSYS | 0 | March 31, 2012 04:12 |