 |
 |
 |
|
|
|
[Sponsors] | ||||
December 14, 2013, 18:05
|
constraining vertices
|
#1 |
|
New Member
Jochem Grietens
Join Date: Nov 2013
Location: Belgium
Posts: 16
Rep Power: 12  |
Dear colleagues,
I have a question regarding the movement of vertices.(referring to the picture) I would like to move certain vertices on my airfoil but i would like the upper vertex(red circle) to be aligned exactly and at all times with the lower vertex drawn. Is there a way to ensure this alignment by some sort of constraint ? Thx in advance ! |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] Internal walls of zero thickness | anger | OpenFOAM Meshing & Mesh Conversion | 23 | February 6, 2020 18:25 |
| [ICEM] Specifying Periodic Vertices Causes Mesh Overlap | Josh | ANSYS Meshing & Geometry | 10 | July 8, 2010 02:39 |
| [blockMesh] How to construct a block with four vertices | jennyrui2008 | OpenFOAM Meshing & Mesh Conversion | 0 | November 5, 2008 20:44 |
| correcting double vertices | Tom | Siemens | 3 | October 3, 2006 19:18 |
| vread not storing all vertices | Chris | Siemens | 6 | May 18, 2005 02:50 |
Linear Mode
