|
[Sponsors] |
January 19, 2014, 08:06 |
The P over the origin
|
#1 |
New Member
magnus nytun
Join Date: Sep 2012
Posts: 9
Rep Power: 13 |
Hi
Just started to use Ansys fluent 14.5. When creating the geometry a P is supposed to appear when you point over the origin, but this does not happen in my case. Does anyone know if this is new with Ansys 14.5, or if it's fixable! Thanks |
|
January 19, 2014, 09:00 |
|
#2 |
Super Moderator
Alex
Join Date: Jun 2012
Location: Germany
Posts: 3,399
Rep Power: 46 |
In sketch mode, you should have a tab called "constraints".
Here you will find the auto-constraints setting that seem to be turned off. Turn them back on. |
|
January 19, 2014, 10:30 |
The P over the origin
|
#3 |
New Member
magnus nytun
Join Date: Sep 2012
Posts: 9
Rep Power: 13 |
Thanks It's working now!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[General] Slice origin as annotation in animation | bozack | ParaView | 6 | July 27, 2018 04:37 |
[Commercial meshers] Origin 0 0 0 has been moved while fluentMeshToFoam | ishimotoj | OpenFOAM Meshing & Mesh Conversion | 4 | May 20, 2013 04:53 |
Harpoon import issue (origin?) | LiveandLetDrive | Main CFD Forum | 1 | April 27, 2009 20:02 |
Coordinate of axis origin | Tang | FLUENT | 0 | October 4, 2004 16:38 |