Blocking help

praphul · February 16, 2014, 14:34

Hi ,

I am relatively new to icem cfd and i am trying to find out the numerical stall in a n airfoil. The airfoil that i did select was a fx79w151a.

Presently i have imported the airfoil geometry and created a wind domain . Wind domain was further divided into various parts like inlet , out let , top , bottom etc. and i did merge the airfoil geometry and wind domain geometry to get a final structure as shown below.

Can anyone help me with blocking how blocking is done and how to associate surfaces ,curves , and thereby creating a mesh on the same. ?

Thanks in advance.

flotus1 · February 16, 2014, 14:45

Dont you think it would be better to do some of the basic tutorials than asking strangers on the internet to write new tutorials for you?

praphul · February 17, 2014, 22:55

Sorry . I will try my level best. Sincere apologies. As u had said i should have checked the tutorials first.

February 16, 2014, 14:34	Blocking help	#1
praphul New Member Praphul T Join Date: Dec 2013 Location: Bangalore, India Posts: 26 Rep Power: 12	Hi , I am relatively new to icem cfd and i am trying to find out the numerical stall in a n airfoil. The airfoil that i did select was a fx79w151a. Presently i have imported the airfoil geometry and created a wind domain . Wind domain was further divided into various parts like inlet , out let , top , bottom etc. and i did merge the airfoil geometry and wind domain geometry to get a final structure as shown below. Can anyone help me with blocking how blocking is done and how to associate surfaces ,curves , and thereby creating a mesh on the same. ? Thanks in advance.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problem to load the blocking	biasilveira	ANSYS Meshing & Geometry	2	February 24, 2013 22:04
[ICEM] Merge blocking	Bollonga	ANSYS Meshing & Geometry	3	February 21, 2013 07:59
[ICEM] Blocking and Symmetry	BrolY	ANSYS Meshing & Geometry	32	August 24, 2012 03:13
[ICEM] Using Blocking with ICEM (infinite blocking lines appeared)	Touré	ANSYS Meshing & Geometry	2	August 5, 2012 17:27
[ICEM] Blocking strategy	BrolY	ANSYS Meshing & Geometry	0	July 22, 2010 04:46

February 16, 2014, 14:45		#2
flotus1 Super Moderator Alex Join Date: Jun 2012 Location: Germany Posts: 3,399 Rep Power: 46	Dont you think it would be better to do some of the basic tutorials than asking strangers on the internet to write new tutorials for you?

February 17, 2014, 22:55		#3
praphul New Member Praphul T Join Date: Dec 2013 Location: Bangalore, India Posts: 26 Rep Power: 12	Sorry . I will try my level best. Sincere apologies. As u had said i should have checked the tutorials first.