[ICEM] extrude faces along a curve -- CFD Online Discussion Forums

November 29, 2014, 04:06

extrude faces along a curve

Sawi

New Member

Ahmed El-Sawi

Join Date: Nov 2014

Posts: 5

Rep Power: 11

when i extrude these faces along the shown curve and specify an end point the extrusion is done only half way?! why? and i would like to merge all zigzag path to one curve and extrude along it but i get negative blocks what i am missing?

Attached Images

BLOCKING.jpg (46.1 KB, 22 views)

November 30, 2014, 06:14	urgently help needed	#2
Sawi New Member Ahmed El-Sawi Join Date: Nov 2014 Posts: 5 Rep Power: 11	Can anyone help me out here please!

December 2, 2014, 10:53		#3
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Tokyo, Japan Posts: 1,385 Blog Entries: 23 Rep Power: 28	use interactive and the associate... __________________ Regards, New to ICEM CFD, try this document --> https://goo.gl/KAOIwm Ali

Tags

blocking, extrude faces, icem 14.5

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Decomposing meshes	Tobi	OpenFOAM Pre-Processing	22	February 24, 2023 09:23
Foam::error::PrintStack	almir	OpenFOAM Running, Solving & CFD	91	December 21, 2022 04:50
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 09:38
snappyhexmesh remove blockmesh geometry	philipp1	OpenFOAM Running, Solving & CFD	2	December 12, 2014 10:58
[Gmsh] Cannot get the right mesh from gmsh	JinBiao	OpenFOAM Meshing & Mesh Conversion	2	August 31, 2010 04:51

All times are GMT -4. The time now is 01:15.