ICEM troblue for meshing Wedge geography
 

hi,Please.

I use ICEM to mesh wedge geography, but at the point of wedge, the mesh is not perfect(Picture mesh.jpg). my ideal mesh is on picture good.jpg
how can i finish my mesh? i want help.

Additionally, in my opinion, the troblue may relate to this problem in picture The quantities of the edge.
there are 30 points in the edge 1 and 40 points in the edge 2. There are, however, 91 points in the edge 3 ! 30 plus 40 is not equal 91 apparently !
when i change the other quantities of edge 1 or 2, the sum of the quantities of edge 3 is 20 more than the sum of the quantities of the edge 1 and 2.

Why and how to handle it?
thx in advance.