[ANSYS Meshing] Need help in Meshing!

Weijie · March 30, 2014, 21:11

Hi, i'm new here and i'm beginner in learning Ansys software. i was trying to run simulation on NACA 8612 airfoil. everything was good in geometry until it came to meshing.

apparently one of my quadrant is messed up when i have no idea why.

can anyone kind enough to give me some advice on this?

kind of urgent as i'm doing it for my final year project in building a vertical axis wind turbine.

i attached the image of my meshing here too.

diamondx · March 31, 2014, 11:18

I guess you followed the tutorial available in Cornell's website. A lot of people face this kind of issue, use the search button of the forum, you will find a solution for it, it has been discussed before... many times

March 31, 2014, 11:18		#2
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Tokyo, Japan Posts: 1,385 Blog Entries: 23 Rep Power: 28	I guess you followed the tutorial available in Cornell's website. A lot of people face this kind of issue, use the search button of the forum, you will find a solution for it, it has been discussed before... many times Far likes this. __________________ Regards, New to ICEM CFD, try this document --> https://goo.gl/KAOIwm Ali

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Best Meshing scheme for Cylinder	Nutrex	Main CFD Forum	4	July 29, 2008 11:03
Meshing locks workbench window.	andy2o	CFX	0	February 1, 2008 05:01
Singularity of grid?Volume meshing vs face meshing	Ken	Main CFD Forum	0	September 4, 2003 11:09
Volume Meshing & Face Meshing? singularity of grid	ken	FLUENT	0	September 4, 2003 11:08